Are you planning to
build a traditional house or something more unusual, designed by the architect,
you should think about creating it using a steel frame.
The use of steel framing
for the house will allow your architect to design something truly unique.
In contrast to the construction of the house of traditional brick and wood,
the use of a steel frame will allow you to build a home in less time and
at less cost.
decoration on the outside of the house, apart from the said materials are
used more and warm plasters, as well as the construction of aerated concrete.
In contrast to the interior, exterior needs extra protection from the negative
effects of snow, rain, sun exposure and weather impacts. Thermal insulation
products are attached to the wall with various adhesives. For these purposes,
used nails, dowels, screws, bars and strips of wood, metal coffee tables,
etc. If used for insulation slabs of glass and mineral wool, in the wall,
you should first install the wooden plugs. It is desirable to strengthen
them with cement mortar. These stoppers are fixed bars, and already installed
insulation between them. In general, the principle of exterior finish is
very similar to an inside job.
Seal coat is protective,
so it is usually presented sheeting, which are covered with stucco exterior.
If the thickness of the vertical rails greater than the thickness of plate
heater, the air gap will be formed. It is closer to the outer plane of
the wall and helps to improve the technical properties erected fencing.
If there is no air gap, instead of asbestos cement sheets can install a
grid of reinforcement. It is attached directly to the bars. After which
the surface is finished with plaster immediately.
Protect walls from
temperature extremes can and using slab insulation, which are mounted between
the horizontal rails. As in the previous embodiment, the bushing is vraspor.
This will help avoid possible deformations contributing gapping heater
to the wall surface. Top of the protections against adverse climatic influences.
This is usually made of asbestos cement corrugated sheets. They are nailed
directly to the fixed horizontal bars. To avoid moisture in the slab insulation,
the outer cover sheets should overlap at least half of the wave. The upper
sheet should cover the bottom from the top. Also to secure mineral plates
on the wall, you can use special metal tables, covered
with a thin layer of zinc. These constructs as podstavochek mounted on
the wall, and then later they established a heater, which is fixed on top
of a special invoice detail.